IC Live Users Manual - Models ICL-R & IC215S-R
38
Same setup as the one shown on the previous page only in a larger room.
At this point the beam steering changes have not been sent to an associated array or stored as a Preset.
ICL-R arrays can store up to 10 different congurations as Presets in their DSP memory, but beam steering data and other conguration
settings can not be saved as a preset in the Virtual mode. The conguration settings can be saved in the project le, but they can not
loaded into an array until one is connected.
When an array is connected selecting either Write to Device or Save as Preset in the Beam Steering window will allow you to send the
beam steering information to the array. The two commands are in the lower right of the beam steering window. Write to Device will send
the beam steering settings direct to the array’s DSP and write over any previous settings. Save to Preset will store the beam settings in the
designated Preset.
If you attempt to leave Beam Steering without saving the setup information, a prompt will remind you that you need to save the settings if
you want to keep them.
Note that the Beam Steering module controls only beam steering. EQ, compression, etc. conguration settings are controlled in the Control
Mode.
Kommentare zu diesen Handbüchern